Thanks Tim... -Ed- ----- Original Message ----- From: "Timothy Williamson" <timvcr@xxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, September 21, 2001 12:19 AM Subject: [TechAssist] Re: Mitsubishi R/P VS-4561R > > --- Tel-Tek Electronics <teltek@xxxxxxxxxxx> wrote: > > > > Have this set in the shop that looked like sound no > > picture. > > After advancing screens slightly found it was > > actually no vertical > > deflection. > > The line is not straight across but has sort of a > > sine wave look to it. > > Although my voltages were correct on the LA7838 > > (Vert O/P) I changed it just > > in case. Same result. > > I can smell something heating up, like a high > > wattage resistor, but can't > > seem to put my finger on it. > > I have no Service Literature on this particular > > model, can anyone help. > > > > > > TIA > > > > > > -Ed- > > Hi:Ed replace ic401 la7838 again,also ck all off the > caps around it and replace D401 even if ck's good. > this time make sure to ck R540 6 ohm 1 watt right off > the flyback.Also replace both str,s on power board and > c914.Then go over to the tuner relay board and ck to > see if one or both of those 12 ohm 3watt resisters are > burnt or open.Hope this helps > > Tim > BCT Electronics > 410-256-0344 > 410-529-1186 fax > > teltek@xxxxxxxxxxx > > > > Tel-Tek Electronics > > Midland > > Ontario. > > Canada > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > __________________________________________________ > Terrorist Attacks on U.S. - How can you help? > Donate cash, emergency relief information > http://dailynews.yahoo.com/fc/US/Emergency_Information/ > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.