--------------------------------------------------------------- Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- MITSUBISHI VS5043 Dead - Relay Clicks Phil Hull Found Ring Cracks On Q904 On Deflection Board. --------------------------------------------------------------- MITSUBISHI VS5043 Dead - Relay Clicks Twice Orlan Stone, Cet Replace Ic900 (Str-M6811), Ic901 (Se130n) And Pc900 (On3161r). Note: Lite Box Pulls For Shop Service. See Vz3 --------------------------------------------------------------- MITSUBISHI VS5043 Dead - Relay Clicks Twice Dan Mundy, Cet/Csm Check Z900 On Power Board For Open. If Open Check Vert Ic 401 La7845 270p064030. --------------------------------------------------------------- MITSUBISHI VS5043 Dead / Customer Complained Of Intermittent Operation Before John Kincaid Sos Tv Strm6811 Power Supply Chip $28 --------------------------------------------------------------- MITSUBISHI VS5043 Dead Set Electric Medic: Perry: 12/16/2002 Found 5 Amp Ac Fuse Blown, Replaced Blew Again, Then Found Regulator Shorted (Strm6811) Replaced Regulator And 5 Amp Fuse Again, All Is Well. --------------------------------------------------------------- MITSUBISHI VS5043 Dead Set. A/C Fuse Bad Hugh/Main Tv Found Bad Parts---Q5a00 2sd2349 H. Output, Ic900 Str-M6811 Pwr. Regulator, And Bad Flyback T5a03 (Cost About $90 From Mits.) #334p24606. Bad A/C Fuse F900 5 Amp. --------------------------------------------------------------- MITSUBISHI VS5043 Power Supply Intermittent Shutdown From Mitsubishi Replace L5a00,If Coil Is Wrapped In Black Tape,With Pt#351p138020, (The New Coil Should Be Wrapped With Yellow Tape).This Is Located On The Main-Pcb. --------------------------------------------------------------- MITSUBISHI VS5043 Power Supply / Plays Awhile And Shuts Off / Interrmittent Phil Hull Found A Defective Ic 900 Part # 267p129010 Str-M6811 Found Problem With Coolent Spray --------------------------------------------------------------- MITSUBISHI VS5043 Shut Down - Goes To Many Horiz Lines Bouncing Around & Hv Shuts Down Stevestv@xxxxxxx Found Severe Ring Cracks On Ic202, Ic203 And Ic401. All Located On Right Front Corner Of Signal Board. Set Still Had Sound When Problem Occurred. --------------------------------------------------------------- MITSUBISHI VS5043 Shutdown (Intermittant) Check For Leakey D5a21, Part # 264p045040, In The Beam Protection Circuit On The Main Pcb Check Pin 6 Off Ic5a01 For 22.2 Volts Dc If Low Check D5a09, Part # 264p244030 On The Main Pcb --------------------------------------------------------------- MITSUBISHI VS5043 Shutdown. Power LED Blinks 3 - Stk391-020 L8w01 And L8w02 (10uh) R8w05 And R8w45 (10-2w) Vert Ic401 (La7845) --------------------------------------------------------------- MITSUBISHI VS5043 Shuts Down At Turn On Mitsubishi 1. Short Detect Shut Down (Pin 15 Of Ic700) Check For Open L902 Part # 351p070010 Off Q904 C (15 V Supply) On The Main Pcb. 2. Short Detect Shutdown (Pin 15 Of Ic700) Check For Shorted D913 Part # 264p722010 And Open Z901 Part # 283p039020 (Z905 And Z900 May Also Be Open Because Of This). 3. X-Ray Shutdown (Pin 55 Of Ic700) Check For A Leaky D5a09 Part # 264p244030 Off Pin 6 Of Ic5a01. 4. X-Ray Shutdown (Pin 55 Of Ic700) Check For Leaky D5a21, Part # 264p045040, In The Beam Protection Circuit On The Main Pcb. 5. Check For Leaky Q5a03 And/Or Q5a04 Both Part # 260p559050, In The High Voltage Detect Circuit, On The Main Pcb. --------------------------------------------------------------- MITSUBISHI VS5043 Shutsdown At Turn On (No Hi Voltage) Bryn Mawr Tv Found Good Horiz Drive Until Shutdown T5a03 Defective 334p246010 Subs To 334p246060 Fly Rings Good Problem Is With Intergrated Splitter --------------------------------------------------------------- --------------------------------------------------------------- Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- MITSUBISHI VZ3 Dead , Rly Clicks Twice, No Hv Slidewire Electronics Resolder L913 Off Pin 4 Of T900 In Ps. Vz3 Chassis --------------------------------------------------------------- MITSUBISHI VZ3 Dead, Clicks On And Back Off, F902 Open Marshfield Tv F902 (4 A Fuse) Hard To See Or Get To, Located In Front Of Main Smps Xfrm, Underneath Standup Board. Also Found Shorted Output, Q5a00, 2sd2349 And Had Bad Flyback, 334p246060, Crc Had It For $90 (Nov `03), Phone 1-909-629-5641. Per Other Tips, Be Sure To Check Regulator Str-M6811, Common To Fail When Output Shorts, This Set Didn'T Need It. --------------------------------------------------------------- MITSUBISHI VZ3 Dead, Power Up. Relay Click Only. Robinson Electronics Replace (Open) 4a. Fuse - "130v. Line F902". Replace (Shorted) H.Output Transistor Q5a02 - D2349 Mfr# 260p797020. Replace (Bad) 3 Mh Choke Coil - L5a01 Mfr# 351p138010. Vz3 Chassis. --------------------------------------------------------------- MITSUBISHI VZ3 No Raster Pulsing Sound From Speakers, Poss Ant Relay Clicks In Time To The Pulsing Bryn Mawr Tv C816 And C5a28 (100uf/200v) C5a03 (4.7uf/200v) --------------------------------------------------------------- MITSUBISHI VZ3 Shutdown At Power On Mela Tip Open L902 P/N 335p070010 On Main Pcb (15 Volt Supply) --------------------------------------------------------------- MITSUBISHI VZ3 Shutdown At Power On, Slight Motorboating Heard Cap'S Tv Open C918 Capacitor (100uf/200v) In The 130v Supply. Located Near The Flyback. --------------------------------------------------------------- Bob Waterman, CET® #RI-28 Master Technician License #9109 Service Manager / Parts Manager Gemini Computer, TV, & Security Alarms (508)695-7302 (508)695-7769 FAX geminitv@xxxxxxxxxxx ----- Original Message ----- From: "armando guerra" <birdie@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, November 09, 2004 2:44 AM Subject: [TechAssist] Mitsubishi Projo Model VS-5043 > This set when powered on,relay clicks on,front led comes on for a few > seconds,relay clicks off again. Last July I replaced the 2 convergence > ic's and the vertical ic.Checked all connections on the power/high > voltage bd.Esr'd all caps in the ps.All the fuses (glass and pico are > ok.The hot is not shorted.I need some info on the supply voltage to the > hot.There is none there.maybe an open resistor.Sure would apreciate any > help.The yoke connections are ok.I resoldered them last yr.Thanks. > Mando > Birdie's TV & Electronics > Casa GRande, AZ > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/