check r416 and q502 good luck >From: "Tony S" <tcselectronics@xxxxxxxxx> >Reply-To: techassist@xxxxxxxxxxxxx >To: <techassist@xxxxxxxxxxxxx> >Subject: [TechAssist] Magnavox TP3272 -32R5 chassis width changes >Date: Wed, 8 Jun 2005 08:49:53 -0500 > >Hello Techs, > >I have a 32" Magnavox 32R5 chassis that the width will slightly bend every >now and then. It seems to happen when set is warm but heat and freeze spray >does not effect the pix. When I get there the set is doing it but after >removing the cover it stops and I cannot get it to happen again, I have >tried tapping board but set is solid. I replaced the B+ filter cap 100uf >200v cap and B+ is pretty steady at 132v -or+ .5v. I extended the width as >far as I could and replaced all the primary side caps in the pws. but set >always seems to act up an hour after I leave. anyone have this problem or a >history on similar problem. > >thanks guys >Tony Saracco >TCS ELECTRONICS >406 Andra Ct. >Gilberts, IL 60136 >tcselectronics@xxxxxxxxx > > >--------------------------------------------------------------------------- -- >This Email List is Public. Remove: http://www.tech-assist.org/remove.htm >Lost Password: http://www.tech-assist.org and select "Login Problems?". >Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app >Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/