[TechAssist] Re: Magnavox 25TS52C303

Pin 3 of the regulator is around 15volts until I turn the set on, then goes to 
149-150volts. Pin 2 is 150 volts when set is on.

> ** Original Subject: RE: [TechAssist] Re: Magnavox 25TS52C303
> ** Original Sender: "Jim Myers" <jr.myers@xxxxxxxxxxx>
> ** Original Date: Fri, 30 Nov 2001 15:01:36 -0500 (EST)

> ** Original Message follows... 

>
> Have you replaced the 3.3uf 200v C431 yet? It is from R431 to ground off pin
> 2 of IC410. I recall seeing this cap causing no regulation in older sets
> using the same regulator IC. Also check D420 connected between pins 4 and 2
> of IC410. This chassis should come on with about 15v on the 130v source in
> standby, then go to 129v when turned on.
> Jim Myers
> jr.myers@xxxxxxxxxxx
> ----- Original Message -----From: <tvdoctors@xxxxxxxxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Friday, November 30, 2001 2:31 PM
> Subject: [TechAssist] Magnavox 25TS52C303
> 
> 
> > Chassis # 25X605    I'm perplexed on this one.  Set is not regulating. It
> comes on with B+ Voltage running at around 149 volts. I tried new and used
> STR30130 regulators (I heard about the bad new ones) and checked just about
> everything in the power supply. Can't get it to 130 volts. Any suggestions,
> Neil
> >
> >
> > TV Doctors    108 W. Main St. Monroe,Wa. 98272    360-794-6469
> >
> > =================================
> > Help make your TechAssist database better!
> > Submit your fixes here: http://circuitwork.com/techassist/tip/#tips
> > =================================
> > To UNSUBSCRIBE your email address, click here:
> > mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
> >
> 
> =================================
> Help make your TechAssist database better!  
> Submit your fixes here: http://circuitwork.com/techassist/tip/#tips
> =================================
> To UNSUBSCRIBE your email address, click here:
> mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe
> 


>** --------- End Original Message ----------- **

> 

TV Doctors    108 W. Main St. Monroe,Wa. 98272    360-794-6469

=================================
Help make your TechAssist database better!  
Submit your fixes here: http://circuitwork.com/techassist/tip/#tips
=================================
To UNSUBSCRIBE your email address, click here:
mailto:techassist-request@xxxxxxxxxxxxx?subject=unsubscribe

Other related posts: