Well if the yoke is hot it is faulty, it has to be. Consider the current required to heat copper wire that thick, it has to be insulation breakdown on load so your test result must be spurious. Robert Orr rrobor@xxxxxxxxxxx R & L TV and VCR Melbourne Australia. >From: "Rudolph" <rudolph@xxxxxxxxxxxxxxxx> >Reply-To: techassist@xxxxxxxxxxxxx >To: <techassist@xxxxxxxxxxxxx> >Subject: [TechAssist] KV35S40 >Date: Sun, 26 May 2002 09:41:55 -0400 > >Hi Techs > > >Have a Sony KV35S40 came in dead. Complaint was that the set was repaired >before and worked for two days and went dead again. Found the horizontal >output shorted and the power supply bad. Resored power supply and replaced >horizontal output and the set works. We ran the set for a couple hours and >discovered that the yoke was getting hot (really hot). The yoke was rang on >sencore LC102 and it rang good, also it looks perfect. Any ideas or help >will be appreciated. I cannot find anything bad. > >Thanks > >Rudolph > >------------------------------------------ >To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html >To CHANGE your email address, click here: > http://www.tech-assist.org/change.html >------------------------------------------ >***NEW*** Tips Added Instantly!!!*** >Submit Repair Tips here: >http://www.tech-assist.org/secure/tip/ _________________________________________________________________ Chat with friends online, try MSN Messenger: http://messenger.msn.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/