[TechAssist] Re: IC # LSC435143P

Hi Monte it is a 40 pin chip in a Daytek Monitor DT1436D it is the micro
The brightness does not adjust pic too bright otherwise ok if I turn
the G2 down and turn it off when it comes on again it is too dark.Do you
know where to get help on Daytek monitors..Thanks Eric

MONTE MONCRIEF wrote:
> 
> Eric
>  What is this out of and used for....??? Is this surface mounted ??
> MONTE MONCRIEF
> BAKERSFIELD , CA. 93304-3946
> DOCVIDEO.1@xxxxxxxxxxxxxxxx
> TEL# 10+10+811+1+661-398-1057
> ----- Original Message -----
> From: "Eric Manuel" <tvman@xxxxxxxxxxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Sunday, July 29, 2001 9:22 AM
> Subject: [TechAssist] IC # LSC435143P
> 
> Hi can anyone tell me where to find the data sheet and pinout for this I
> C
> I tried Free Trade Zone didnt come up..Thanks Eric
> Help make your TechAssist online repair tips
> database better!  Submit your fixes here:
> http://geocities.com/circuit_work/tip/#tips
> To unsubscribe write to:
> techassist-request@xxxxxxxxxxxxx
> with  unsubscribe  in the subject line.
> 
> Help make your TechAssist online repair tips
> database better!  Submit your fixes here:
> http://geocities.com/circuit_work/tip/#tips
> To unsubscribe write to:
> techassist-request@xxxxxxxxxxxxx
> with  unsubscribe  in the subject line.
Help make your TechAssist online repair tips 
database better!  Submit your fixes here: 
http://geocities.com/circuit_work/tip/#tips
To unsubscribe write to:
techassist-request@xxxxxxxxxxxxx 
with  unsubscribe  in the subject line.

Other related posts: