Wayne, Do you have similar info on a Hitachi AP-84 chassis? I have a IHVT on this one that rings 29 times out of circuit, but my analyzer still shows it pulling excess current. M# 60SBX78B CH# AP-84 John Myers Myers TV Service Since 1984 Alliance, OH ph 330-821-6545 ----- Original Message ----- From: "Wayne Vanaman" <Wayne@xxxxxxxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, June 22, 2004 10:34 AM Subject: [TechAssist] Re: GE 27GT619 (CTC185AB) Power problem > From some of my notes: > > CTC197 NOTES > > > > IHVT 237506 2 good units measured. > Pins 2-3 ring 57, 54 on the z-meter. Measures 2.77, 2.85 mH > Pins 1-2 ring 29, 25 and measures 1.49, 1.43 uH > Pins 1-3 ring 57, 54 and measures 2.52, 2.64 mH > Pins 6-10 ring 48, 41 and measures 530, 540 uH > On the TVA > Pins 1-3 ring 30, 31 > Pins 1-2 ring 14, 16 > Pins 2-3 ring 30, 32 > Pins 6-10 ring 36, 36 > > Pin 5-anode leaks 2 mA > > BAD UNITs z-meter > pins 2-3 ring 19, 40 > pins 1-2 ring 2, 17 > pins 1-3 ring 18, 39 > pins 6-10 ring 7, 30 > On the TVA > Pins 2-3 ring 15, 27 > Pins 1-2 ring 0, 11 > Pins 1-3 ring 14, 26 > Pins 6-10 ring 0, 26 > > > > > > Wayne Vanaman > Omega Electronics > 6904 W Fairfield Dr > Pensacola, Fl. 32506-3310 > > Wayne@xxxxxxxxxxxxxxxxxxxxx > WWW.PensacolaTVRepair.Com > > 850-456-5995 voice > 850-458-6369 fax > > > ----- Original Message ----- > From: "al m" <ampm@xxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Tuesday, June 22, 2004 7:56 AM > Subject: [TechAssist] Re: GE 27GT619 (CTC185AB) Power problem > > > > How many rings? I had a CTC197 that was clicking 3 times, which is bad > fly. > > When I took it out it rang 16 times, the good one rang 38 times. Just a > > thought. > > Al Marquardt > > ampm@xxxxxxx > > Al Marquardt Electronic Repair > > 206 W Main > > Girardville Pa. 17935 > > ----- Original Message ----- > > From: "Shaun" <satguy@xxxxxxxxxxxxx> > > To: "tech" <techassist@xxxxxxxxxxxxx> > > Sent: Monday, June 21, 2004 4:18 PM > > Subject: [TechAssist] GE 27GT619 (CTC185AB) Power problem > > > > > > > This set had the horz. output shorted the regulator shorted and 2.7 ohm > 15 > > > watt power resistor open. I replaced them all and the 231523 kit. Now > the > > > set turns on but it is drawing about 3.5 AMPS and is probably going to > > blow > > > parts if I leave it on too long. What else am I missing. I read through > > all > > > the tips but nothing really stands out other than the I.H.V.T but it > rings > > > good. > > > > > > Shaun > > > > > > Advanced Electronics > > > 224 West Riverview Ave. > > > Fort Morgan, CO 80701 > > > > > > > > > > -------------------------------------------------------------------------- > > --- > > > Lost Password: > > > http://www.tech-assist.org and select "Login Problems?". > > > Email Archives: > > > //www.freelists.org/archives/techassist/ > > > > > > > > > > > > > > -------------------------------------------------------------------------- > --- > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/