I've seen the yoke go bad in these a few times. Usually you can see the burnt damage inside if you take it off the crt. Gavin Baker c/o Frazer TV & Electronics Repair Inc. ----- Original Message ----- From: "Phil Bader" <philbad@xxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, October 18, 2001 4:44 PM Subject: [TechAssist] [Fwd: Sylvania console SRP753 (25S102 chassis)HOT,pico fuse blows] > > > > -------- Original Message -------- > Subject: Sylvania console SRP753 (25S102 chassis)HOT,pico fuse blows > Date: Thu, 18 Oct 2001 16:33:15 -0400 > From: Phil Bader <philbad@xxxxxxxxxx> > Organization: Jan Phyl TV Inc. Winter Haven, Fl. Estab. 1976 > To: "CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx" > <CONSUMERELREPAIR-L@xxxxxxxxxxxxxxxxxxxx> > > Found HOT Q502 shorted and 2.5a pico B+ fuse open . Replaced HOT and > fuse,plugged in and checked standby volts. I only had +15V at coll of > HOT, but the +9V and +5V stby was good.Did not find any shorted small > transistors or diodes.Turned on,heard a rush of HV and SSSSSHHHOOP.dead. > HOT and pico fuse bad again. Pulled the scan cap C505 (10nF@1600V) > measured OK. Any history on this? Phil > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.