[TechAssist] Fw: 3M OVERHEAD MODEL 9060

----- Original Message ----- 
From: Mitchs Electronics 
To: techassist@xxxxxxxxxxxxx 
Sent: Tuesday, September 30, 2003 1:55 PM
Subject: 3M OVERHEAD MODEL 9060


This overheads lamp melted the top cover. Their isn't any heat shield directly 
above the ENX lamp.
3m says their should be but my question to you fellows is:
Does this metal shield mount to the top cover? Or to the lamp?
Because if to top cover it was never installed at the factory and heads will 
roll. 3m did not know.
Mr. R. L. Mitchell
Mitch's Electronics
Lincoln, NE  68502
Mitchstv@xxxxxxxxxx
*****************************************************************************
Classifieds! Buy or Sell!
http://sell.tech-assist.org
The Tech Address Book:
http://www.tech-assist.org/secure/tip/contact.htm
Add a Repair Tip Here, or Change/Remove your Email Address:
http://www.tech-assist.org/secure/tip/main.htm
Lost Password:
http://www.tech-assist.org  and select "Lost your Login Info?".
Email Archives:
http://www.freelists.org/archives/techassist/

Other related posts: