After several hours of troubleshooting, found the tuner to have bad connections. Removed and soldered inside the tuner. Thanks to Joe Searles, Gary M.and everyone else for their help and Russ Gray for sending me a print. Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net ----- Original Message ----- From: <support@xxxxxxxxxxxxxxxxxx> To: "Techassist" <techassist@xxxxxxxxxxxxx> Sent: Friday, December 26, 2003 12:26 PM Subject: [TechAssist] Fisher(Sanyo) PC8120 (1988) No video/audio, just snow Set has chassis A8S81200 I ruled the tuner out, but do not have a schematic. A/V inputs produce good video. If I disconnect the tuner and input a signal, I still don't get anything. As I was looking for bad connection, found PCB cut on IC101 pin 10/11. This appears to be intentional, so I don't know if another shop did this as a modification. I repaired the trace, but still no video. This set came in with a bad flyback, I tested it fine, but when I turned it on today, found this problem. Any ideas? Thank you. Jeff Dougherty Intrepid Video TV/VCR 263 S Front St Steelton PA 17113 fax...717-564-4952 www.intrepid-video.com www.tech-repair.net ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/