[TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Wed, 5 May 2004 17:13:32 -0400
Don,
I suggest you make sure your post is at the top of the email..
all lines on this reply look like part of the previous email.
Jeff
--
Intrepid Video TV/VCR Repair
263 S Front St, Steelton PA 17113
717-939-7708; (F) 717-564-4952
www.intrepid-video.com www.tech-repair.net
----- Original Message -----
From: <MagLfixIt4ya@xxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Wednesday, May 05, 2004 2:50 PM
Subject: [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
In a message dated 5/4/2004 4:09:51 PM Eastern Daylight Time,
tjanphyl@xxxxxxxxxxxxxxx writes:
> Subj: [TechAssist] Re: VCR, Go Video DDV9550 New problem
> Date: 5/4/2004 4:09:51 PM Eastern Daylight Time
> From: tjanphyl@xxxxxxxxxxxxxxx
> Reply-to: techassist@xxxxxxxxxxxxx
> To: techassist@xxxxxxxxxxxxx
> Sent from the Internet
>
> Ok Phil, It turns out there was a cable just slightly out, I must have
> knocked it out when putting the set back together and thanks for the
> nomination
> for the seat of president of the "TIP" club but I must decline, can I be VP?
> (-; LOL!
> Don
> well, as the local president of the "TIP" club (Technician- Induced-
> Problems) I am qualified to assist.
> I found when I did similar things it was components that got laid over
> on the board and touched another lead. Look closely for any parts bent
> over or touching. probe around. Also on some of these units with
> interconnections where a ribbon cable mates with a strip, there can be a
> problem seating.
> just a thought.
> You may unseat me as local president! ;-)
> Good luck, friend.
> Phil Bader
>
> MagLfixIt4ya@xxxxxxx wrote:
>
> >In a message dated 5/3/2004 3:22:37 PM Eastern Daylight Time,
> >support@xxxxxxxxxxxxxxxxxx writes:
> >
> >
> >>Subj: [TechAssist] Re: VCR, Go Video DDV9550 looks like bad heads
> >>Date: 5/3/2004 3:22:37 PM Eastern Daylight Time
> >>From: support@xxxxxxxxxxxxxxxxxx
> >>Reply-to: techassist@xxxxxxxxxxxxx
> >>To: techassist@xxxxxxxxxxxxx
> >>Sent from the Internet
> >>
> >>Hello all, thank you to everyone who responded to this post, the bellow
> >>solution fixed the original problem, however now I have a new problem and
> I dont
> >>know what happened. After restoring a good pic I put the unit back
> together
> >>and tested again but this time I have no video at all, not from antenna
> out
> >>and not from video out (RCA connections), I am not even getting the blue
> >>screen. I took it apart and put it back together again to see if there was
> a bad or
> >>loose connection but still nothing. Im not sure if I did something to
> loose
> >>the video or if this was just waiting to happen, what ever happened Im in
> the
> >>dark, any help is appreciated.
> >>Don from Affordable Electronics.
> >>Don,
> >>Check for poor ground connections on preamp section, first. If there's a
> >>place for a screw there, replace
> >>the screw and try it. Flex the ribbon cable and see if symptoms improve.
> >>Jeff
> >>--
> >>Intrepid Video TV/VCR Repair
> >>263 S Front St, Steelton PA 17113
> >>717-939-7708; (F) 717-564-4952
> >>www.intrepid-video.com www.tech-repair.net
> >>----- Original Message -----
> >>From: <MagLfixIt4ya@xxxxxxx>
> >>To: <techassist@xxxxxxxxxxxxx>
> >>Sent: Monday, May 03, 2004 12:42 PM
> >>Subject: [TechAssist] VCR, Go Video DDV9550 looks like bad heads
> >>
> >>
> >>Hello all, Playback of known good tape (movie) on deck 2 has video noise,
> I
> >>cleaned heads but no cigar, then switched heads from deck 1 to deck 2 and
> >>put
> >>deck 2's heads in deck 1, deck 2 side still has the noise so I am ruling
> out
> >>bad heads. The noise looks like stars with tails across the screen. Has
> >>anyone
> >>seen this? Any help is appreciated.
> >>
> >>Don@ Affordable Electronics Repair
> >> 153 Garfield Place
> >> Brooklyn NY 11215
> >> 718-788-0384
> >>
> >>
> >>
> >>
> >>
> >>
> -----------------------------------------------------------------------------
> >>
> >>Lost Password:
> >>http://www.tech-assist.org and select "Login Problems?".
> >>Email Archives:
> >>http://www.freelists.org/archives/techassist/
> >>
> >>
> >>
> >>
> -----------------------------------------------------------------------------
> >>
> >>Lost Password:
> >>http://www.tech-assist.org and select "Login Problems?".
> >>Email Archives:
> >>http://www.freelists.org/archives/techassist/
> >>
> >>
> >>
> >
> >
> >
> >
> >
> -----------------------------------------------------------------------------
> >Lost Password:
> >http://www.tech-assist.org and select "Login Problems?".
> >Email Archives:
> >http://www.freelists.org/archives/techassist/
> >
> >
> >
>
> --
>
> Philip Bader
> Jan Phyl TV Inc. (estab. 1976)
> 3420 Recker Hwy. Winter Haven, Fl. 33880
> Fax (863) 299-8821
> email: tjanphyl@xxxxxxxxxxxxxxx
>
>
>
> -----------------------------------------------------------------------------
>
> Lost Password:
> http://www.tech-assist.org and select "Login Problems?".
> Email Archives:
> http://www.freelists.org/archives/techassist/
>
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
http://www.freelists.org/archives/techassist/
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
http://www.freelists.org/archives/techassist/
- References:
- [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- From: MagLfixIt4ya
Other related posts:
- » [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- » [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- » [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- » [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- » [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- [TechAssist] Re: Fixed VCR, Go Video DDV9550 New problem
- From: MagLfixIt4ya