[TechAssist] Fixed.. UPD.... PA Zenith Z25X22S RX3209...Chassis swapped
- From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Sat, 30 Oct 2004 23:43:55 -0400
Thanks Max..
Unit is fixed..
When I removed the original C3201, I think I lifted the solder pad.
Repaired that and replaced the other two caps in vertical circuit, set fixed.
Jeff
--
Intrepid Video TV/VCR Repair
263 S Front St, Steelton PA 17113
717-939-7708; (F) 717-564-4952
www.intrepid-video.com www.tech-repair.net
----- Original Message -----
From: "Old TV Man" <mebonnell@xxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Thursday, October 28, 2004 9:21 PM
Subject: [TechAssist] UPD.... PA Zenith Z25X22S RX3209...Chassis swapped
Jeff - I have the Zenith schematic on the 9-1558 if you want any of it
scanned.
Have you checked C3208?
Max Bonnell
Bonnell TV
Robinson, IL
Sender: techassist-bounce@xxxxxxxxxxxxx From:
support@xxxxxxxxxxxxxxxxxx(Intrepid=A0Video=A0Support) Date: Thu, Oct
28, 2004, 3:16pm (CDT+1) To: techassist@xxxxxxxxxxxxx Subject:
[TechAssist] UPD.... PA Zenith Z25X22S. RX3209...Chassis swapped.
Reply=A0to: techassist@xxxxxxxxxxxxx
Thanks to Kevin Harris..and Bob W for sending me the parts list, I just
found out someone pulled a chassis swap on me and this one has the
9-1558.
I did confirm the resistor is correct, but the vertical output still
blows.
Jeff
--
Intrepid Video TV/VCR Repair
263 S Front St, Steelton PA 17113
717-939-7708; (F) 717-564-4952
www.intrepid-video.com www.tech-repair.net ----- Original Message -----
From: "Intrepid Video Support" <support@xxxxxxxxxxxxxxxxxx>
To: "Techassist" <techassist@xxxxxxxxxxxxx>
Sent: Thursday, October 28, 2004 2:27 PM
Subject: [TechAssist] PA Zenith Z25X22S. RX3209
No schematic.
Set came in with blown vertical LA7833 and RX3209 open. Resistor looked
like it was a 1 ohm..used a one ohm and vertical IC blew again..though
not the same way as the original.(By taking ohms reading) and the
resistor was OK I'm beginning to think maybe this resistor should have
been the common 2.2 ohm. First badn could be a brown or red, second one
is defintely black.. Can someone verify for me? I also replaced HIGH ESR
C2100. All caps and feed diode check ok. Thank you.
Jeff
--
Intrepid Video TV/VCR Repair
263 S Front St, Steelton PA 17113
717-939-7708; (F) 717-564-4952
www.intrepid-video.com www.tech-repair.net
----------------------------------------------
-----------------------------------------------------------------------------
Lost Password:
http://www.tech-assist.org and select "Login Problems?".
Email Archives:
//www.freelists.org/archives/techassist/
Other related posts:
- » [TechAssist] Fixed.. UPD.... PA Zenith Z25X22S RX3209...Chassis swapped
