Parts List calls CM102,Disc Stop Sensor PCB. Exploded Views shows it is connected(wires) to CM108. Problem is,it looks like they are mounted under the Turntable. Pin 13 of connector CN156,is the 'Sense' pin of this Disc Stop Sensor. It goes to Pin 2 of IC111,CXP82432-101Q. 5v to the Disc Stop Sensor(at pin 14 of CN156),Ground and the Sense Pin. I'm not sure how this sensor counts/selects any particular disc(1-24). Peggs At 11:12 AM 6/9/05, Paul Westcott wrote: >Fisher TAD-993 >When a disc is inserted into this unit, >the carousel rotates 2 or three complete revolutions, stops, then the >display shows mech. error. >It somehow doesn't sense the disc. >I know about the slip gears that go bad, >but they are O.K. >I need to know how the unit senses a disc and its position. >As always, thanks in advance. >Paul Westcott >Kingsway Electronics >1090 Kingsway >Sudbury, Ontario >Canada >Phone 705 566-9290 >Fax 705 566-5349 >westcott@xxxxxxx > >----------------------------------------------------------------------------- >This Email List is Public. Remove: http://www.tech-assist.org/remove.htm >Lost Password: http://www.tech-assist.org and select "Login Problems?". >Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app >Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- This Email List is Public. Remove: http://www.tech-assist.org/remove.htm Lost Password: http://www.tech-assist.org and select "Login Problems?". Appliance Repair List: http://www.tech-assist.org/secure/tip/chatjoin.htm#app Email Archives: //www.freelists.org/archives/techassist/