It is located near the vert output ic, tracing it back it goes to cr14704 that is connected to a pin of the flyback, also correction the17.1 vdc reading is off of cr14108.tia Country TV Ron Miller Inez, TX. 77968 ----- Original Message ----- From: "George" <grndmstrg@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, December 10, 2003 11:26 AM Subject: [TechAssist] Re: CTC 203CX1 F36665 ,Won't stay on R14509 discolered need value > On the CTC203aa the cathode of cr14106 is the 130 volt source and cr107 is a > 33 volt Zener diode (34.5 v source). What circuit is R14509 in? > > George > Afana Electronics > Moreno Valley, CA > > ----- Original Message ----- > From: "Ron Miller d.b.a. Country TV" <rlmbkm@xxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Wednesday, December 10, 2003 8:45 AM > Subject: [TechAssist] CTC 203CX1 F36665 ,Won't stay on R14509 discolered > need value > > > > Push power button clicks on with HV for about 1 second clicks off, push > > button again same thing .Do not have to unplug to reset. > > Notice R14509 is discolored it reads 223 ohms out of circuit is this > > correct? K of cr14106 has 139.7 vdc on it in standby mode and cr14107 > > has17.1vdc on it's K. > > Country TV > > Ron Miller > > Inez, TX. 77968 > > > > > > > **************************************************************************** > * > > Lost Password: > > http://www.tech-assist.org and select "Login Problems?". > > Email Archives: > > //www.freelists.org/archives/techassist/ > > > > > **************************************************************************** * > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > > ***************************************************************************** Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/