Try replacing C7768 and C7773 they can cause this problem Phillip R Hull phil245@xxxxxxxxxxxxx ----- Original Message ----- From: "Robert Herring" <supertek66@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, August 28, 2001 2:10 PM Subject: [TechAssist] Re: (((2nd Post - Toshiba PTV))) > > Bil, > I have had some intermittent convergence problems with red which turned out > to be yoke. > the blue and green yokes are the same except the connector if you want to > swap them for testing > Robert > supertek66@xxxxxxxxxxx > robert_herring@xxxxxxxx > H&H Electronics Inc > Dallas,Tx. 75233 > ----- Original Message ----- > From: "Bil Green" <tv.vcrrepair@xxxxxxxxxxx> > To: ".Techassist" <techassist@xxxxxxxxxxxxx> > Sent: Monday, August 27, 2001 4:40 PM > Subject: [TechAssist] (((2nd Post - Toshiba PTV))) > > > > > > Toshiba TP50F50 (or any set using a digital > > convergence module) > > 1996 PTV > > Both STK392-110 chips replaced > > > > In a 10 minute period I saw the convergence go > > bad in 3 different ways! First the red jumps way > > over to the left for two seconds. > > > > Then the convergence became bad all over > > and the bottom of the raster was bent in (only > > some colors actually bent in). > > > > The picture was good when in between symptoms. > > > > Then the convergence went bad again - similar to > > the second symptom. Has anyone found the > > digital convergence module to cause this? I > > already replaced both STK392-110 chips and > > resoldered the module pins on the PC board. > > > > Thanks, > > > > Bil > > > > > > Help make your TechAssist online repair tips > > database better! Submit your fixes here: > > http://www.circuitwork.com/techassist/tip/#tips > > To unsubscribe write to: > > techassist-request@xxxxxxxxxxxxx > > with unsubscribe in the subject line. > > > Help make your TechAssist online repair tips > database better! Submit your fixes here: > http://www.circuitwork.com/techassist/tip/#tips > To unsubscribe write to: > techassist-request@xxxxxxxxxxxxx > with unsubscribe in the subject line. > > Help make your TechAssist online repair tips database better! Submit your fixes here: http://www.circuitwork.com/techassist/tip/#tips To unsubscribe write to: techassist-request@xxxxxxxxxxxxx with unsubscribe in the subject line.