[TechAssist] Re: 1995 RCA TV

I ran into this problem once before with the same channels you are having
problems with. The RF connector was slightly loose where it is press fitted
into the ground shielding. The problem was intermittent, but soldering
around the connector at the shield solved the problem.
----- Original Message -----
From: "albert marquardt" <ampm@xxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Sunday, September 02, 2001 2:01 PM
Subject: [TechAssist] Re: 1995 RCA TV


>
> i agree with jonas i've run in the problem with soder splashes, bridges
> al marquardt
> ampm@xxxxxxx
> ----- Original Message -----
> From: Jonas Miglinas <miglinasj@xxxxxxxx>
> To: <techassist@xxxxxxxxxxxxx>
> Sent: Sunday, September 02, 2001 8:41 AM
> Subject: [TechAssist] Re: 1995 RCA TV
>
>
> >
> > i've found solder splashes that can cause this and other similiar
problems
> .
> > looking at the bottom of the board and the cable input on your right,
> most
> > of the splashes were on the lower right hand corner near tuner tabs
where
> > you have to resolder. use a magnefying glass. also found them near u7301
> > good luck    jonas
> > ----- Original Message -----
> > From: "Russell Hornsby" <undertaker48@xxxxxxxx>
> > To: <techassist@xxxxxxxxxxxxx>
> > Sent: Sunday, September 02, 2001 2:06 AM
> > Subject: [TechAssist] 1995 RCA TV
> >
> >
> > >
> > > Hi All:
> > > TV TYPE: RCA CONSOLE
> > > MODEL # G25343WK
> > > CHASSIS # CTC 177AM2
> > > I have a RCA 25" console, came in dead, and I got it running with no
> > > problem, I did soldered all connections that I could find and now I
have
> > > a problem with the channels.
> > > Channels 1-50 are GOOD, but Channels 51-57 are snowy, Channel 55 acts
> > > like no signal. Has anybody run across this before.
> > > Any help would be greatly appreciated.
> > > Thank You
> > > Russ
> > > Hornsby Electronics
> > > North Vernon, Indiana
> > > Help make your TechAssist online repair tips
> > > database better!  Submit your fixes here:
> > > http://www.circuitwork.com/techassist/tip/#tips
> > > To unsubscribe write to:
> > > techassist-request@xxxxxxxxxxxxx
> > > with  unsubscribe  in the subject line.
> >
> > Help make your TechAssist online repair tips
> > database better!  Submit your fixes here:
> > http://www.circuitwork.com/techassist/tip/#tips
> > To unsubscribe write to:
> > techassist-request@xxxxxxxxxxxxx
> > with  unsubscribe  in the subject line.
> >
>
> Help make your TechAssist online repair tips
> database better!  Submit your fixes here:
> http://www.circuitwork.com/techassist/tip/#tips
> To unsubscribe write to:
> techassist-request@xxxxxxxxxxxxx
> with  unsubscribe  in the subject line.

Help make your TechAssist online repair tips 
database better!  Submit your fixes here: 
http://www.circuitwork.com/techassist/tip/#tips
To unsubscribe write to:
techassist-request@xxxxxxxxxxxxx 
with  unsubscribe  in the subject line.

Other related posts: