As far as I know the sender is original to the bus. My guess would be built up crud excepting the bus can go a long ways when the needle is on "E". It's like the range of the needle shifted to the left 1/4".
----- Original Message ----- From: "Eric Woodall" <eric@xxxxxxxxxxxxxx>
To: <tcb@xxxxxxxxxxxxx> Sent: Thursday, May 08, 2008 8:23 AM Subject: [tcb] Re: Gas Guage problems
First, I don't think there is any adjustment. Did you check to see if the gage is grounded well. If it's not the gage then I can see it being a couple of other things: Is it a bay tank in a split? If so, did you replace the split sender with a bay sender? Could be that the sender is old and has built up crud in the tube causing it to stick 3/4 up and thus not reading full on the gage. Dan wrote:When my tank is full my gas gauge only reads 3/4's Is there a way to adjust it? -Dan-- No virus found in this incoming message. Checked by AVG.Version: 7.5.524 / Virus Database: 269.23.9/1419 - Release Date: 5/7/2008 7:46 AM