Hi All, When do the PCB routing for high speed design from point to point. There is a requirement that we need to match the trace length for each net in the= group. If there is a serie termination between the two point, is it require= that each segment(each net before the termination should equal and each net after the termination should be equal) to be match in length or can we only match the total length of the trace(lenght of segment of trace before the termination + lenght of segment of trace after the termination). Thanks in advance for all your help. pornchai ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List FAQ wiki page is located at: http://si-list.org/wiki/wiki.pl?Si-List_FAQ List technical documents are available at: http://www.si-list.org List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu