[SI-LIST] edge slope in eye diagram


                Hello si-list,

                Currently we've been observing the behavior that we would
like to understand better.

                The setup is the following:

                SerDes driver - 16inch of 100 ohm differential trace -
SerDes receiver

                SerDes devices are internally terminated to 100ohm.

                Equipment : Agilent86100 DCA.
                Differential 6330 Tektronix probe.

                The attached picture is the sample of what we are seeing at
the receiver end.
                We are not using the pre-emphasis at this point.

                As you can see from the picture a transition from one state
to the other always hesitates at about the 2/3s 

             point and then continues the transition.

             What we expected from this picture is that the signal at the
receiver would continue its exponential rise
             until a state change and not the hesitation mentioned above.

             Any input on this subject is greatly appreciated.

          Regards,
          
         Alexander Nosovitski
                anosovit@xxxxxx
 <<16inchtrace.bmp>> 


-- Binary/unsupported file stripped by Ecartis --
-- Type: image/bmp
-- File: 16inchtrace.bmp


------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages 
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu

Other related posts: