[SI-LIST] Re: Time domain AMS-SI tools

Mark.
:As is initial stab at understanding to include such effects one must
:tell the tool at which frequency we would like the simulation run and an
:internal 2D field solver will allocate appropriate parameters for skin
:effect etc at that frequency and then run waveforms through the model.

The frequency is often used to set the mesh spacing of the 2D field solver, as 
this is a finite element process.
Obviously, smaller mesh sizes take longer to calculate. Also, knowing the 
frequency will allow enable the use of low frequency approximations where 
appropriate e.g. remove small parasitics.

Regards

Andrew


------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List FAQ wiki page is located at:
                http://si-list.org/wiki/wiki.pl?Si-List_FAQ

List technical documents are available at:
                http://www.si-list.org

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu

Other related posts: