cody If you have just an s11 file, you can configure a 1-port s-parameter model in HSPICE, and drive it with a pwl and 50 ohm source impedance through a 50 ohm transmission line. That should give you the correct reflected waveform. regards, Scott Scott McMorrow Teraspeed Consulting Group LLC 121 North River Drive Narragansett, RI 02882 (401) 284-1827 Business (401) 284-1840 Fax http://www.teraspeed.com Teraspeed® is the registered service mark of Teraspeed Consulting Group LLC codymiller@xxxxxxxxxx wrote: > All, > > Does anyone in the group know of any available software packages that > can take post measurement S11 data and convert it to a time domain > reflected signal? > > Thanks, > Cody Miller > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > > List technical documents are available at: > http://www.si-list.net > > List archives are viewable at: > //www.freelists.org/archives/si-list > or at our remote archives: > http://groups.yahoo.com/group/si-list/messages > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > > > > ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu