[SI-LIST] Press fit connectors

Hi,
Can we use a press fit connector of 2.2mm lead on a PCB with thickness 2.4mm 
for connecting a daughter card. How reliable will be this connection in a long 
run.
Have anyone used press fit connector in this scenario. We are using for a 
medical application so we are worried about the reliability.


Regards,
Suvedha

________________________________
This message (including attachment if any) is confidential and may be 
privileged. If you have received this message by mistake please notify the 
sender by return e-mail and delete this message from your system. Any 
unauthorized use or dissemination of this message in whole or in part is 
strictly prohibited. E-mail may contain viruses. Before opening attachments 
please check them for viruses and defects. While MindTree Limited (MindTree) 
has put in place checks to minimize the risks, MindTree will not be responsible 
for any viruses or defects or any forwarded attachments emanating either from 
within MindTree or outside.

Please note that e-mails are susceptible to change and MindTree shall not be 
liable for any improper, untimely or incomplete transmission.

MindTree reserves the right to monitor and review the content of all messages 
sent to or from MindTree e-mail address. Messages sent to or from this e-mail 
address may be stored on the MindTree e-mail system or else where.

------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field


List technical documents are available at:
                http://www.si-list.net

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu

Other related posts: