Hi Ahmed, Perhaps the extra capacitance of the POT also aided in the fix. Thanks Jim Freeman "Alokby, Ahmed" wrote: > DEAR Folks, > I have a 14MHZ clock, series terminated with a 30 Ohms resistor that exhibit > non monotonic edge. Since my output driver has very wide range of output > impedance (20-60 Ohms) my initial reaction was to adjust the termination > resistor to get red of this problem. I replaced the 603 termination > resistor with a through hole POT keeping the wires between the POT and the > resistor pads to a minimum length. When dialing the POT I was able to find > a value that completely eliminated the reflection on the clock. However, > when I replaced the POT with a discrete 603 resistor with equal value the > edge comes back. Can one explain this to me? > > Ahmed > ------------------------------------------------------------------ > To unsubscribe from si-list: > si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field > > or to administer your membership from a web page, go to: > //www.freelists.org/webpage/si-list > > For help: > si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field > > List archives are viewable at: > //www.freelists.org/archives/si-list > or at our remote archives: > http://groups.yahoo.com/group/si-list/messages > Old (prior to June 6, 2001) list archives are viewable at: > http://www.qsl.net/wb6tpu > ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu