Hi All, I am using the Hyperlynx boardsim v6.00. I am facing a problem in using the quickswitch ibis model with this. When i am selecting this model it shows only as input in the buffer setting of the switch model. I want to check a signal which is going out of this quick switch to another component. But as i am not able to select the ibis model of the quick switch in the o/p format(driving point) i am not able to proceed. Can any one of you help out in this case ? Thanks Santhosh ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu