Dear SI'ers, Rather than go through the painful process of calling Avant! I thought some of you may have run across this error. When running HSPICE the simulation runs completely, however the TR0 file is hosed up. In my output file I get the following statement:: ** On entry to DGELS parameter number 10 had an illegal value Have any of you seen this before?? If so were you able to get around it? Thanks, Peter -- Peter LaFlamme Applied Micro Circuits Corp. Staff System Applications Engineer 200 Minuteman Rd, 3rd Floor Andover, MA 01810 978-247-8470 phone 978-623-0055 Fax ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu