Content-Type: text/plain;
charset="US-ASCII"
Content-Transfer-Encoding: quoted-printable
Hello Ivor,
I had a similar x64 DDR2 requirement in one of my designs.
I used 4 nos of x16 devices with the following topology. The same
topology should work for you as well.
But I would advice you to simulate.
=20
Best Regards,
Dhiraj
-----Original Message-----
From: si-list-bounce@xxxxxxxxxxxxx [mailto:si-list-bounce@xxxxxxxxxxxxx
<mailto:si-list-bounce@xxxxxxxxxxxxx> ] On Behalf Of Ivor Bowden
Sent: Thursday, February 23, 2006 4:52 AM
To: si-list@xxxxxxxxxxxxx
Subject: [SI-LIST] DDR2 design
Hi SI Experts,
I am reviewing a layout for an embedded DDR2 design using 4 Micron DDR2
chips with an Altera Cyclone controller. The memory is set up to be 64
bits wide, 16 bits per chip.
The target rate is 167MHz. The design is not simulated.
Termination is as follows:
ODT may be supported, still investigating.
There is no series term.
There is 0.9V stub term for control lines.
There is a differential 100 ohm term for each clock pair (4 total).
Routing is as follows:
Control lines are daisy chained and length matched between the first
DRAM and controller (about 1"), each DRAM (about .75") and the last DRAM
and terminators (about .25"); total net length is about 3.5".
Data lines are length matched at about 3" (controller to DRAM).
Clock lines are length matched at about 4" (controller to DRAM).
Trace impedance is targeted at 100 ohms for clock and control lines, and
75 ohms for data lines.
Is this design likely to work? If not, what changes should be
considered?
I very much appreciate all comments. Thank you!
Ivor Bowden
Engineer
Curtiss-Wright Controls
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list
<http://www.freelists.org/webpage/si-list>=20
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List FAQ wiki page is located at:
http://si-list.org/wiki/wiki.pl?Si-List_FAQ
<http://si-list.org/wiki/wiki.pl?Si-List_FAQ>=20
List technical documents are available at:
http://www.si-list.org <http://www.si-list.org/>=20
List archives are viewable at:=20
http://www.freelists.org/archives/si-list
<http://www.freelists.org/archives/si-list>=20
or at our remote archives:
http://groups.yahoo.com/group/si-list/messages
<http://groups.yahoo.com/group/si-list/messages>=20
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu <http://www.qsl.net/wb6tpu>=20
=20
-- Binary/unsupported file stripped by Ecartis --
-- Type: image/jpeg
-- File: Outlook.jpg
-- Desc: Outlook.jpg
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List FAQ wiki page is located at:
http://si-list.org/wiki/wiki.pl?Si-List_FAQ
List technical documents are available at:
http://www.si-list.org
List archives are viewable at:
http://www.freelists.org/archives/si-list
or at our remote archives:
http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu