[SI-LIST] Copper pour under inductor?

Hi. Is it recommendable not to place copper pour (GND net) under and close
to a surface mount inductor? (DIGIKEY PART #: 490-2493-1-ND)
(the inductor's winding axis is perpendicular to the PCboard, the PCB is a
two layer board).
Besides of not placing and IC on the opposite side of the board and
disallowing any traces running under the inductor... what other
guidelines should be followed when inductors are involved in a situation
like this?. Could anybody please point me towards
some documentation about it?

Thanks in advance.


-- 
Carlos Toro B
Design Engineer
JAVERIANA STEREO
Calle 18 No. 118-250
Cali, Colombia
South America

Office Phone: +57 2 2725032
Mobile Phone: +57 315 474 5872


------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List FAQ wiki page is located at:
                http://si-list.org/wiki/wiki.pl?Si-List_FAQ

List technical documents are available at:
                http://www.si-list.org

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu

Other related posts: