[SI-LIST] Contact Protection

Dear all:
In almost every product, hot-plug should be available. When the boards is plug 
into the back plane, the power supply would be affected and some error bits 
would take place. The operation interval of plug in or out is of ms. The 
disturb on the PDS should be below 1MHz. However, I have get some obvious noise 
of ns.

I have read some material in Ott's Noise Reduction Techniques in Electonic 
Systems. But the book is older than me :) I could not find the reference paper 
and book. Is there some new good material on this topic? Any advice will be 
helpful.

Best Regards

Zhangkun
2004.5.23


------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field

or to administer your membership from a web page, go to:
http://www.freelists.org/webpage/si-list

For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field

List FAQ wiki page is located at:
                http://si-list.org/wiki/wiki.pl?Si-List_FAQ

List technical documents are available at:
                http://www.si-list.org

List archives are viewable at:     
                http://www.freelists.org/archives/si-list
or at our remote archives:
                http://groups.yahoo.com/group/si-list/messages
Old (prior to June 6, 2001) list archives are viewable at:
                http://www.qsl.net/wb6tpu

Other related posts: