[python] Re: p1 and p3 news

Thanks Jurgen.  So far the front end is the same as your P3.  My inseam will 
allow for a 24.5" wheel to fit inside the frame.  I just ordered a couple of 
tires for the 559 rims I own that are 26X1.00 high pressure road tires.  These 
are exactly 24" in diameter, giving me a .25" clearance.  Not much room to 
spare!  I am going to custom mount fenders to the BB's.  So far, I am very 
pleased with the turnout.  If I can get a hold of a digital camera, I will 
shoot you some photos.
Cheers,
Scott

-----Original Message-----
From: python-bounce@xxxxxxxxxxxxx [mailto:python-bounce@xxxxxxxxxxxxx] On 
Behalf Of Jürgen Mages
Sent: Wednesday, June 02, 2004 2:17 PM
To: python@xxxxxxxxxxxxx
Subject: [python] Re: p1 and p3 news

Scott,

> Here's a neophyte question for you:  Is the 67 degrees measured
> from the joint to rear frame, or from the ground/level?

Steering angle is generally measured from the ground level.

> P.S. I got to weld for the first time last night!
> The front end came together nicely!

Good news. Any details about your project?

Jürgen.

============================================================

This is the Python Mailinglist at freelists.org

Listmaster: Juergen Mages jmages@xxxxxx

============================================================

============================================================

This is the Python Mailinglist at freelists.org

Listmaster: Juergen Mages jmages@xxxxxx

============================================================

Other related posts: