[python] Re: VOILA: next Python finished
Sehr schön, Stephan! The matchbox idea is clever. If I were you I would weld triangular reinforcement plates where the pivot fork meet the middle frame in order to reduce flex. 

olaf



On 15 dec 2006, at 17.38, Stephan Schöling wrote:


OK,
i´d better say nearly finished, because of some things are still to do. 
But its ready to ride !
The Bike has a Z-Frame, the front ant the rear part have the same angle. 
The Frame is separable at the SBB by unscrewing 4 little screws.
There is no suspension.
The Wheels are both 26", with 55-559 MTB-Tyres.
I have fitted V-Brakes and 3x7 Gears.

You can see it on the attached Picture or visit my project pages:
http://www.schoeling.net/python.html
At this point i´d like to thank all, who have helped me solving my problems in the construction. All individual details on the webpages of the builders were helpful, thanks for that too. 

@Juergen:
If you´d like to put this python to your project-survey, i´d suggest to wait till the last work is done. Also I didn´t do the terminal measurements of all the Frame - Geometry related things ;-) 
I hope to find time next week.

Greetings,
Stephan
<IMGP0015.JPG>




============================================================

This is the Python Mailinglist

http://www.freelists.org/list/python

Listmaster: Jürgen Mages jmages@xxxxxx
To unsubscribe send an empty mail to python-request@xxxxxxxxxxxxx 
with 'unsubscribe' in the subject field.

============================================================

Other related posts: