[python] Re: Python Suspension Rubber

Thanks Jürgen!

I'll order the harder one (314-179) per your advice. FWIW I found these here
if anybody else is looking;

http://www.spaenaur.com/products.asp

Cheers
Daryl

-----Original Message-----
From: python-bounce@xxxxxxxxxxxxx [mailto:python-bounce@xxxxxxxxxxxxx] On
Behalf Of Jürgen Mages
Sent: Tuesday, May 10, 2005 12:19 PM
To: python@xxxxxxxxxxxxx
Subject: [python] Re: Python Suspension Rubber


Daryl,

I use a similar one. The shape is cylindrical, 50 mm
diameter and 45 mm height. Shore is 80 degrees and
hole is M10.
I think yours is ok, but I would choose the harder
one.

Regards,
Jürgen. 

============================================================

This is the Python Mailinglist at freelists.org

Listmaster: Juergen Mages jmages@xxxxxx

============================================================

Other related posts: