[pure-silver] Re: floor vibration?

My enlarger timer has a plug marked "safe light" on the back. Whatever is plugged in there automatically goes off when you start timing something. If you put the fan on a plug and plugged it into the safelight plug on the timer it would run all the time until you hit print.. presto no fan no vibration for a little while. 

Dennis


On Sep 29, 2008, at 14:06, Shannon Stoney wrote:
I have a question about the new darkroom that I'm building in a garage in my back yard.
My old darkroom was a box inside a garage. The floor was a concrete slab.
In the new darkroom, we had a wooden floor built on top of the slab, because the slab was so uneven. The walls are now tied in with the floor, and there is a vent hood mounted on one wall, with a fan on a shelf next to the hood to pull air through the vent hood. In the old darkroom, the vibration from the fan vibrated the wall, but not the enlarger, because the enlarger sat on a table on the concrete slab.
Today I suddenly got worried that the vibration from the vent fan on the vent hood over the sink would vibrate the floor, because now the floor is tied in with the wall. Then if the floor vibrates, the table that the enlarger sits on might vibrate also. 

So, what should I do to prevent this from happening?

--shannon
======================================================================= ====================================== To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there. 



=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your 
account (the same e-mail address and password you set-up when you subscribed,) 
and unsubscribe from there.

Other related posts: