[pure-silver] Re: flattening old black an white film


----- Original Message ----- From: "Mark" <aerialphotos@xxxxxx>
To: <pure-silver@xxxxxxxxxxxxx>
Sent: Monday, August 29, 2005 7:25 PM
Subject: [pure-silver] flattening old black an white film


Well I have some older black and white negs I would like to print. One big problem. When the orginal processing was done, they just rolled the negs without cutting them on to a cardboard spool looking container that now leaves the film effectively spooled for life. I would much rather be able to cut these and store them in more current negative holders but they just are not flat enough.

Is there a safe way to deal with getting these flat enough to both print easily and store in something like Vue All or what ever neg storage. Thanks in advance Mark


The problem is they might be brittle due to some degradation in the support. Normally, curling is due to the different rate of shrinkage of the emulsion from the support. Most films have a back coating of gelatin to compensate for this, at least partially, but cellulose base (both nitrate and acetate) can absorb and loose moisture. The age of the film is important, if its from the 1950's it may well have gotten brittle.
I don't know what the current thinking is about the best practice. I think it would be safe enough to expose the rolled up film to high humidity for a time to see if it straightens out. If it does then dry it by hanging with a weight at the bottom.

---
Richard Knoppow
Los Angeles, CA, USA
dickburk@xxxxxxxxxxxxx 

=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your 
account (the same e-mail address and password you set-up when you subscribed,) 
and unsubscribe from there.

Other related posts: