> > -> >> >> Do you cut the Holga negative strip apart, so that >> you just have one >> negative rather than a strip? >> >> I have a glass negative carrier for the DeVere, but >> the edges of it >> damage the strip if I don't cut the strip apart. >> >> > Shannon > > No, I cut the MF negatives into strips that fit into > pages, and then put the whole strip in the carrier. > The neg carrier that I am using is made for 4"x5", and > I just put a mask on it which masks down to 6cmx4.5cm > - haven't had issues with damage to the negs. The > resulting sandwich is less satisfying for the MF case > than it is for the LF panoramic case - with MF, I put > the mask over the negative, so that the emulsion side > of the neg is against the lower glass, then the mask, > then the top of the neg carrier. > > I have a Beseler 45 - don't know how different the neg > carriers from your DeVere - have never used one of > those. > > Mark > > I've also used foam core to fashion negative carriers for the occasional odd size. I'd be mindful of the lamp heat but with a cold light head it got the job done without any problems. Mark =============================================================================================================> To unsubscribe from this list, go to www.freelists.org and logon to youraccount (the same e-mail address and password you set-up when yousubscribed,) and unsubscribe from there.> ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.