[pure-silver] Re: Mistakes Galore

Or take off the lens before replacing the darkslide.....

john (:>))) I also removed the filmholder before replacing the darkslide 
once..... I got so addled that I put the darkslide in, and then had to 
develop the the whole batch (e-6) anyhow.....

Howard Efner wrote:

>>A few years later, I was working, freelance, out of a commercial studio in
>>Palo Alto CA and they got a job in to develop a dozen sheets of 8x10. I had
>>developed a lot of 8x10 film using hangers and hard rubber tanks, but this
>>studio didn't have the equipment. So I developed them in a tray, just like
>>I had developed pack film previously. Pack film is very thin and limber.
>>8x10 sheet film is very stiff and rigid. All of the 8x10 film came out
>>scratched to kingdom come! The customer WAS NOT happy. I learned the tray
>>developing lesson the hard way.
>>
>>:-)
>>
>>Jim
>>    
>>
>
>
>Simple way to solve the problem of scratching film during development is to 
>simply forget to load the holders before going to the field.   <:-|
>
>
>
>=============================================================================================================
>To unsubscribe from this list, go to www.freelists.org and logon to your 
>account (the same e-mail address and password you set-up when you subscribed,) 
>and unsubscribe from there.
>
>  
>
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your 
account (the same e-mail address and password you set-up when you subscribed,) 
and unsubscribe from there.

Other related posts: