[pure-silver] Re: How to build a sink in a corner ?

Greetings  Ken;  A photo would help to show your ' Stacker System'  I am 
interested !
You wrote:   When I started to enlarge 8x10 negs my sink was too small. It 
was one of those Gemini molded plastic ones 6ft long x 24in wide with a 
deep end. My
>prints got to be 24x36. The trays would not fit. So I designed a stacked 
>system. five trays. deve, rinse, fix, rinse, hypo clear and then another
>wash tray next to the stack. Each tray has a valved drain on the side of 
>each tray.Each valve has a hose to the bottom gemini sink.It's pretty easy
>to pull a print and slide it into the next tray. Cleans up easy. Stacking 
>works great.  Ken  Cheers BarrieB.
>
>=============================================================================================================
>To unsubscribe from this list, go to www.freelists.org and logon to your 
>account (the same e-mail address and password you set-up when you 
>subscribed,) and unsubscribe from there.
-------------------------------------------------------------------------------------------------------
barrieb@xxxxxxxxxxxxxxxxxxxx{ Melbourne , Australia }  
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your 
account (the same e-mail address and password you set-up when you subscribed,) 
and unsubscribe from there.

Other related posts: