[pure-silver] Re: Easel masks?

On Friday 22 June 2007 10:59, mail1 wrote:
> Nick,
>  I use black mat board for RC paper, and a 20'x24" vacuum easel with a
> black mat board for FB paper. To process you can use a Jobo 2800 print drum
> system by adding 2 2870 modules to a 2830 tank. The tank would be 32" long.
> This tank would handle 16"x30" easy. A tank with a single 2870 module would
> handle 16"x20" print The solution beaker in the lid holds 300cc which might
> be enough to process print on a single use of the solution.200cc solution
> is adequate for 16"x20". You could lengthen the beaker if you needed more.
> The drum works this way you load the print pour in solution. Secure cap,
> turn on lights, lay drum on side which introduces liquid from beaker, then
> roll on table top.


        Will the ridges inside the 2800 tank work with 12" paper? I hadn't 
thought of 
using two extensions. The beaker volume isn't a big issue. All you need to do 
is fill it. Turn it on it's side so the chemicals flow into the tank. Pop it 
back up and pour in the rest of the chemicals. I do that for film in the 
print tank.

        Nick
=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your 
account (the same e-mail address and password you set-up when you subscribed,) 
and unsubscribe from there.

Other related posts: