[pure-silver] Re: Drying prints in blotter roll

Thank you , Richard,
I stand corrected.  Good thing I asked. <phew>

Cheers,
Bogdan

Richard Knoppow wrote:


----- Original Message ----- From: "Bogdan Karasek" <bkarasek@xxxxxxxxxxxx>
To: <pure-silver@xxxxxxxxxxxxx>
Sent: Sunday, September 28, 2008 11:03 AM
Subject: [pure-silver] Drying prints in blotter roll


Hi,

I just wanted to double check since I haven't used them often. In a blotter roll, the prints go face down on the blotter and the print back is on the muslin backing? Right???

Cheers,
Bogdan

Blotter rolls, books, etc, have a smooth surface material intersperced with the blotters. The emulsion side of the paper should be against the smooth surface. This is partly to prevent particles of the blotter from sticking to the emulsion and partly to control the relative rate of drying of the emulsion vs the support. Curling of paper is mostly due to the difference in shrinking of the emulsion vs the paper. The emulsion dries out much faster than the paper so if its drying rate can be slowed down the shrinkage is equalized to some extent and curling minimised. The smooth surface, usually something resembling waxed paper, is to slow the drying rate of the emulsion side.

--
Richard Knoppow
Los Angeles, CA, USA
dickburk@xxxxxxxxxxxxx
============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.



--
________________________________________________________________
 Bogdan Karasek
 Montréal, Québec                     bogdan(at)bogdanphoto.com
 Canada                               www.bogdanphoto.com

                    "I bear witness"
________________________________________________________________


=============================================================================================================
To unsubscribe from this list, go to www.freelists.org and logon to your 
account (the same e-mail address and password you set-up when you subscribed,) 
and unsubscribe from there.

Other related posts: