I develop in d-76 straight, 5 mins in new and 5 1/2 in replenished on Jobo. Comes out great, clients like it. Eric ________________________________ From: Bogdan Karasek <bkarasek@xxxxxxxxxxxx> To: pure-silver@xxxxxxxxxxxxx Sent: Sunday, December 14, 2008 12:55:12 PM Subject: [pure-silver] Re: Developing Plus-X in Rodinal 1+100 Hi, The problem is that the Massive Development Chart doesn't give a recommended time for PX at 125 iso or 64 iso in Rodinal 1+100. Bogdan Tim Daneliuk wrote: >Bogdan Karasek wrote: > > >>Hi, >> >>I'm planning on shooting some 120 Plus-X at the rated 125 iso and I want >>to develop it in Rodinal 1+100. I checked the Massive development Chart >>and it gives 6 min for Rod 1+25 and 13 min for Rod 1+50. What would be >>the extrapolation for the time if I developed in Rod 1+100? I figure a >>ballpark time of around 18-19 minutes. Does somebody have a more >>precise time? >> >>In passing, is 125 iso a good starting point or should I be shooting >>with a lower iso, say 64. Haven't used Plus-X since high school in the >>60's, so I am unfamiliar with what I assume is an updated version of >>Plus-X or has it stayed essentially the same emulsion? >> >>Any info about Plus-X would be appreciated, pros and cons. >> >>Cheers, >>Bogdan >> >> >> > >I shoot PX at ASA 64, and develop in HC-110 or D-76 or PMK Pyro >depending on the subject. In all cases - assuming your thermometer >and timers are OK, start with a dev time about 20% shorter than >recommended. > > > -- ________________________________________________________________ Bogdan Karasek Montréal, Québec bogdan(at)bogdanphoto.com Canada www.bogdanphoto.com "I bear witness" ________________________________________________________________ ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.