[pure-silver] Re: Darkroom advice needed

To wash just a few keepers on site, you might transport one or two 5-gallon jugs of water with a valve on the bottom of each jug. Set the jug(s) up on a shelf and attach them (one at a time) to a rinsing tray. Adjust the valve(s) so water runs slowly down and through the rinsing tray. You could also have a couple of extra empty jugs to capture the used rinse water, rather than letting it run out onto the ground.

HowardDvorin@xxxxxx wrote:

Hello,

My present darkroom is makeshift. However, I now have space for a nice size darkroom. But there isn't any plumbing. For Printing I can carry in and out developer, stop and fixer. I can bring in enough water to soak the prints in a tray. The question is... How can I transport wet 11 x 14 prints to my washing facility 8 miles away?

Quantities are small, I will be able to print one or two evenings a week and make about 3 to 5 keepers at best.

       Ideas and suggestions are sought.

Thanks

Howard Dvorin
Mt Laurel NJ, USA



--
John Bower     http://www.studioindiana.com/


Other related posts: