We connected and then I was left in connected mode. I think there is a latency problem here. Maybe it is on your side, since my client can do long file transfers to other servers. If you run a Signalink USB, then set the DLY knob fully anti-clockwise + 1 notch clockwise. Will try again tomorrow. On Wed, May 2, 2012 at 9:36 PM, Bernard Dekok <kc9sgv@xxxxxxxxx> wrote: > Is your FLDigi RXid and TXid on ? > > > On Wed, May 2, 2012 at 9:33 PM, Bernard Dekok <kc9sgv@xxxxxxxxx> wrote: > >> Same here. >> I think you are not on frequency, or do not follow an off frequency >> signal. >> >> In FLDigi : >> >> Configure>Modems>Misc>PSKMail >> >> 1000 >> 50 >> 3 >> 50 >> >> Check Reset to carrier >> Check Report ARQ frames average S/N >> >> Save >> Close >> >> >> On Wed, May 2, 2012 at 8:02 PM, Andrew O'Brien <k3ukandy@xxxxxxxxx>wrote: >> >>> Glen, your station is responding to my Pings on 40M but not responding >>> when I send a Connect command. Pings returned have been 69% and 82% >>> >>> Andy K3UK >>> Fredonia NY (near Buffalo) >>> >>> >>> On Wed, May 2, 2012 at 7:32 PM, Glenn Roeser Roeser <wb2lmv@xxxxxxxxx> >>> wrote: >>> > Hi Bernard, >>> > My server is now on 7.103 usb dial + 1K I will leave it there >>> overnight. I >>> > hope that you will be able to upload your data successfully. >>> > Very 73, Glenn >>> >>> >> >