After some analysis I see that you are using a mode (PSK250) which is not in the default mode table. You could change the mode table to: PSK250-PSK250R-PSK125R-THOR22-THOR11 and try again... this is one of the combinations I have succesfully tested... Rein PA0R -- http://pa0r.blogspirit.com -----Ursprüngliche Nachricht----- Von: "Rein Couperus" <rein@xxxxxxxxxxxx> Gesendet: Aug 21, 2011 9:06:16 PM An: pskmail@xxxxxxxxxxxxx Betreff: [pskmail] Re: No Connection >The new client (1.3.4) sends a mode table to the server on connect. >You can configure the mode table yourself (Preferences->Edit->Modes). >Both client and server (1.4.0) are alpha, so they are not guaranteed to work. >Of course they have been tested thoroughly, and it works fine here, >but there is no guarantee that it also works your end... > >I'd like to find out why it does not work for you... > >Rein PA0R > > >-- >http://pa0r.blogspirit.com > >-----Ursprüngliche Nachricht----- >Von: ve7cus@xxxxxxx >Gesendet: Aug 21, 2011 8:56:29 PM >An: pskmail@xxxxxxxxxxxxx >Betreff: [pskmail] No Connection > >>I have upgraded the server and my client to v1.4.0(the client shows 1.3.4) >>and now I cannot connect to the server. Everything else works fine; Beacon, >>Link, Ping, etc. I went back to v1.0 which is the only one I see on the >>hermes site and all is okay. >> >>here is what the client sends to the server on 1.4(1.3.4) >>10cVE7CUS:1024 VE7SUN:24 8765432160BE >> >>Here is what v1.0 sends >>10cVE7CUS:1024 VE7SUN:24 84B14 >> >>What is happening with the new version? >> >>Darrel, VE7CUS >> >> >> > >