Ed, you have to load the Net::GPSD module via cpan. Then start gpsd with 'gpsd /dev/ttyS0'. You if you start gpsd before pskmail, pskmail will automatically recognize the gps. I have written a wiki page on the subject... 73, Rein PA0R > -----Ursprüngliche Nachricht----- > Von: pskmail@xxxxxxxxxxxxx > Gesendet: 20.05.07 15:24:50 > An: pskmail@xxxxxxxxxxxxx > Betreff: [pskmail] Re: Client install help > > Ed wrote: > > I get the following error when I start ./psk_arq.pl > > > > > > Can't locate Net/GPSD.pm in @INC (@INC contains: ./lib ../lib /etc/perl > > /usr/local/lib/perl/5.8.8 /usr/local/share/perl/5.8.8 /usr/lib/perl5 > > /usr/share/perl5 /usr/lib/perl/5.8 /usr/share/perl/5.8 > > /usr/local/lib/site_perl .) at arq.pm line 70. > > BEGIN failed--compilation aborted at arq.pm line 70. > > Compilation failed in require at ./psk_arq.pl line 43. > > BEGIN failed--compilation aborted at ./psk_arq.pl line 43. > > > > > > > > Also I'm not clear on gpsd. Do I start the daemon at boot and what do I > > enter when I run dpkg to configure gpsd ? I can't get it to run, I get > > this error > > > > > > Starting GPS daemon: gpsdgpsd: can't run with neither control socket nor > > devices > > - failed. > > > > > > > > > > Ed W3NR > > > > > > > Well I'll just answer my own question. After an hour or so of sifting > through the mail list, I found that I didn't have this: > > sudo cpan Net::GPSD > > > Both problems solved. > > > Ed W3NR > > > > > -- http://pa0r.blogspirit.com