CAT is working on 2.0.9, supported by hamlib.
I have tested that with my K3 (in my FT897 the CAT interface is broken,
but it used to work with /dev/ttyUSB1. /dev/ttyUSB0 is the gps...)
Rein PA0R
Il 15/04/2012 16:55, Joerg Schroeder ha scritto:
> Hi Franco, Hi Gunnar
> I have also an EEEPc 1000
> (must be a good pc hi hi)
> I have problems with Hardware PTT.
> Incomming Signal is ok. But I can not switch to connect.
> So I did not know if outgoining signal is ok.
> I have a Alinco DX 70 on the boat. It has no VOX or CAT interface.
Are you using PTT connected to a serial USB simulated or are you using
CAT for PTT?
I suspect that CAT port preferences is not saved. I have forced it
downloading from SVN and changing Main.
Is CAT OK?
Franco Spinelli
IW2DHW