-=PCTechTalk=- Re: No Dial Sound

it is already in there as "atm1" so I am looking for other than the
obvious solution.  I assume that "atm1" which was put in
automatically by my system is the same as "AT M1"????

Thanks

Don

On Wed, 24 Oct 2007 10:07:40 -0400 "BIG MARC" <bigmarctech@xxxxxxxxx>
writes:
> *You can writhe in the command line    AT M1   *
> *Where M1 is speaker always on until connect  AT  is the required 
> command
> prefix*
> *Good luck !*
> *BIGMARC*
> *========*
> 
> 2007/10/24, Don Elias <donelias@xxxxxxxx>:
> >
> > Greetings
> >
> > I am running W98SE on a dial-up connection and a while
> > back the dial tones and subsequent  "screeching" had gone
> > away and there was only silence.  Now I am one of the few
> > (apparently) who likes to hear those sounds so I know what
> > is going on.  After a while the sounds came back and I was
> > happy.  :^)  Now all of a sudden they are again silent and I
> > would like to get them back.  I have tried the obvious but it
> > has not worked.  What am I missing?
> >
> > Thanks
> > Don


---------------------------------------------------------------
Please remember to trim your replies (including this sentence and everything 
below it) and adjust the subject line as necessary.

To unsubscribe or change your email settings:
http://www.freelists.org/webpage/pctechtalk

To access our Archives:
http://groups.yahoo.com/group/PCTechTalk/messages/
http://www.freelists.org/archives/pctechtalk/

To contact only the PCTT Mod Squad, write to:
pctechtalk-moderators@xxxxxxxxxxxxx
---------------------------------------------------------------

Other related posts: