-=PCTechTalk=- Re: No Dial Sound

*You can writhe in the command line    AT M1   *
*Where M1 is speaker always on until connect  AT  is the required command
prefix*
*Good luck !*
*BIGMARC*
*========*

2007/10/24, Don Elias <donelias@xxxxxxxx>:
>
> Greetings
>
> I am running W98SE on a dial-up connection and a while
> back the dial tones and subsequent  "screeching" had gone
> away and there was only silence.  Now I am one of the few
> (apparently) who likes to hear those sounds so I know what
> is going on.  After a while the sounds came back and I was
> happy.  :^)  Now all of a sudden they are again silent and I
> would like to get them back.  I have tried the obvious but it
> has not worked.  What am I missing?
>
> Thanks
> Don
>
>
> ---------------------------------------------------------------
> Please remember to trim your replies (including this sentence and
> everything below it) and adjust the subject line as necessary.
>
> To unsubscribe or change your email settings:
> http://www.freelists.org/webpage/pctechtalk
>
> To access our Archives:
> http://groups.yahoo.com/group/PCTechTalk/messages/
> http://www.freelists.org/archives/pctechtalk/
>
> To contact only the PCTT Mod Squad, write to:
> pctechtalk-moderators@xxxxxxxxxxxxx
> ---------------------------------------------------------------
>
>



---------------------------------------------------------------
Please remember to trim your replies (including this sentence and everything 
below it) and adjust the subject line as necessary.

To unsubscribe or change your email settings:
http://www.freelists.org/webpage/pctechtalk

To access our Archives:
http://groups.yahoo.com/group/PCTechTalk/messages/
http://www.freelists.org/archives/pctechtalk/

To contact only the PCTT Mod Squad, write to:
pctechtalk-moderators@xxxxxxxxxxxxx
---------------------------------------------------------------

Other related posts: