Dan,
After defining the data points you can choose any number of
points on the curve that passes through the data (piece-wise linear approx.
by default). Try choosing 272 points instead of 271.
In any case you might want to return a Nurbs and round off the sharp
corner.
...Bill
On Mon, Oct 10, 2016 at 11:18 AM, Dan Kokron <dkokron@xxxxxxxxx> wrote:
All,
I have a working overture-26 on a fedora-24 system, at least the internal
test run and verify. For my first Overture project, I decided to build a
model rocket like you might find at your local hobby shop. Basically a 46
cm long tube with three fins and a 10 cm elliptical nose cone. I used the
sub.cmd file as a guide. It turns out splines are no good for this project
as I need sharp corners at the aft end. I have tried a dataPointMapping
for the nose profile using a point set generated with octave. The trouble
is that Overture is moving the aft-most y value closer to the x-axis giving
me something less than a 90 degree turn. See attached cmd file. Is anyone
else seeing this kind of behaviour?
Dan