Re: Oracle RAC multiple Nic for Private network vs interconnect bonding

  • From: "Sanjay Mishra" <dmarc-noreply@xxxxxxxxxxxxx> (Redacted sender "smishra_97" for DMARC)
  • To: "contact@xxxxxxxx" <contact@xxxxxxxx>, Oracle-L Freelists <oracle-l@xxxxxxxxxxxxx>
  • Date: Mon, 21 Aug 2017 19:57:34 +0000 (UTC)

Thank Stefan. Will go thru the details also as per provided doc link.
Did we tried to increase the css miscount to 45 from 30 and can share any 
experience.
Sanjay 

    On Monday, August 21, 2017 1:38 PM, Stefan Koehler <contact@xxxxxxxx> wrote:
 

 Hello Sanjay,
yes, several of my clients are using HAIP and it works pretty good. However 
there is an important detail if you want to switch from bonding to HAIP (MOS ID 
#1210883.1).

----
If using the 11.2.0.2 (and above) Redundant Interconnect/HAIP feature (as 
documented in CASE 2 below) - At present it is REQUIRED that all interconnect 
interfaces be placed on separate subnets.  If the interfaces are all on the 
same subnet and the cable is pulled from the first NIC in the routing table a 
rebootless-restart or node reboot will occur. 
----

Best Regards
Stefan Koehler

Independent Oracle performance consultant and researcher
Website: http://www.soocs.de
Twitter: @OracleSK

Sanjay Mishra <dmarc-noreply@xxxxxxxxxxxxx> hat am 21. August 2017 um 19:04 
geschrieben:

Hi

Can someone share his experience in using multiple NIC for Private network 
and therby focing Oracle to use multiple HAIP vs interconnect bonding. I had 
RAC setup where OS level Private network Bonding is not failing over due to 
one issue on NIC and causing Oracle cluster to bounce the node. This happen 
several time and so checking Oracle Docs that says that 11g(11.2) onwards it 
is recommended to use multiple nic and details from DOc is

"With Redundant Interconnect Usage, you can identify multiple interfaces to 
use for the cluster private network, without the need of using bonding or 
other technologies. This functionality is available starting with Oracle 
Database 11g Release 2 (11.2.0.2). If you use the Oracle Clusterware 
Redundant Interconnect feature, then you must use IPv4 addresses for the 
interfaces.
When you define multiple interfaces, Oracle Clusterware creates from one to 
four highly available IP (HAIP) addresses. Oracle RAC and Oracle Automatic 
Storage Management (Oracle ASM) instances use these interface addresses to 
ensure highly available, load-balanced interface communication between nodes. 
The installer enables Redundant Interconnect Usage to provide a high 
availability private network.
By default, Oracle Grid Infrastructure software uses all of the HAIP 
addresses for private network communication, providing load-balancing across 
the set of interfaces you identify for the private network. If a private 
interconnect interface fails or become non-communicative, then Oracle 
Clusterware transparently moves the corresponding HAIP address to one of the 
remaining functional interfaces." 

So want to check is someone is using and share the experience

TIA
Sanjay
--
//www.freelists.org/webpage/oracle-l



   

Other related posts: