[modeleng] Re: pictures

Ian, would you give us a heads up when the photos of
your shaper are postd?

Al Messer, proud owner of a South Bend Seven Shaper

--- "I.D.PRIEST." <idpriest@xxxxxxxxxxxxxxxx> wrote:

> Gents,
> 
> I've just applied to post some pictures on Tels site
> of my newly aquired 
> shaper what did recently come out of a school.  A
> viceroy 250, very nice it 
> is too and cost me nowt.
> 
> Regards IDP
> 
> "Life should NOT be a journey to the grave with the
> intention of arriving
> safely in an attractive and well preserved body, but
> rather to skid in
> sideways, Champagne in one hand - strawberries in
> the other,
> body thoroughly used up, totally worn out and
> screaming WOO HOO - What a
> Ride!"
> 
> "Never drive faster than your gaurdian angel can
> fly"
> 
> Priest & Sons Model Engineers
> http://www.kinvermes.pwp.blueyonder.co.uk/p1.htm
> 
> ----- Original Message ----- 
> From: "alan stepney" <alan@xxxxxxxxxxxxxxxx>
> To: <modeleng@xxxxxxxxxxxxx>
> Sent: Saturday, April 15, 2006 4:52 PM
> Subject: [modeleng] pictures
> 
> 
> In fact, Tel did set up a website so that people
> could share pictures.
> It is at:
> 
>
http://groups.msn.com/TELsGlobalModelEngineering/shoebox.msnw
> 
> but doesnt seem to get much use.
> 
> If there is the demand, I could set up a site just
> to enable list members to
> post photos, and then they could be seen by all list
> members.
> However, Tel's site is up and running already.
> 
> Alan
> ----- Original Message ----- 
> From: "Jesse Livingston" <fernj1@xxxxxxxxxxxxx>
> To: <modeleng@xxxxxxxxxxxxx>
> Sent: Saturday, April 15, 2006 2:02 AM
> Subject: [modeleng] Re: Stuart 10V-now age
>   I wish we could post a photo of the engine and
> frame
> castings here but we can't.  There are some photos
> on:
> http://bbs.livesteam.net/ubbs/forumdisplay.cgi under
> the heading of "end
> grain".
> Jesse in Tennessee
> 
> 
> MODEL ENGINEERING DISCUSSION LIST.
> 
> To UNSUBSCRIBE from this list, send a blank email
> to,
> modeleng-request@xxxxxxxxxxxxx with the word
> "unsubscribe" in the subject 
> line.
> 
> 
> 
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.385 / Virus Database: 268.4.1/312 -
> Release Date: 14/04/2006
> 
> 
> MODEL ENGINEERING DISCUSSION LIST.
> 
> To UNSUBSCRIBE from this list, send a blank email
> to, 
> modeleng-request@xxxxxxxxxxxxx with the word
> "unsubscribe" in the subject line.
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: