[modeleng] Re: [modeleng]running Conway

See----I knew you could do it!  Good show!

Al Messer

--- Kenneth Swales <kenwillowbend@xxxxxxxxx> wrote:

> 
> --- Kenneth Swales <kenwillowbend@xxxxxxxxx> wrote:
> 
> > Hi
> > 
> > I stripped it down and even though it all felt
> free
> enough, I decided to ease the sides of the slide.
> 
> Re steamed it and at first thought I had the same
> problem until there was a klunk from the engine and
> she took off. 
> 
> It just shows with the expansion it must have locked
> the valves of the seats.
> 
> My son in law is always complaining about toolroom
> fitters.
> 
> Anyway thanks for all the advice.
> 
> I'll be down the BHR track on Sunday to give it a
> good
> try out.
> 
> Thanks again
> 
> Ken
> 
> 
>       
>       
>               
>
___________________________________________________________
> 
> Yahoo! Messenger - NEW crystal clear PC to PC
> calling worldwide with voicemail
> http://uk.messenger.yahoo.com
> MODEL ENGINEERING DISCUSSION LIST.
> 
> To UNSUBSCRIBE from this list, send a blank email
> to, 
> modeleng-request@xxxxxxxxxxxxx with the word
> "unsubscribe" in the subject line.
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
MODEL ENGINEERING DISCUSSION LIST.

To UNSUBSCRIBE from this list, send a blank email to, 
modeleng-request@xxxxxxxxxxxxx with the word "unsubscribe" in the subject line.

Other related posts: